DRILL MAG PRESS SMALL

$899.00
MILW4270-20

For remote drilling in metal, the 4270-20 is a great choice. The entire tool weighs just 26-1/2 pounds and has a comfortable carrying handle well positioned for balance, with cutter wrenches stored on-board. This is a very portable machine. However, power was not sacrificed for portability. This drill press includes a very powerful 1.1 maximum horsepower, 9.0 amp motor. It can drill up to 1-1/2 in. diameter holes through 2 in. thick steel with annular cutters, or 1/2 in. diameter holes 4-1/4 in. deep with twist drill bits. The tool is setup to accept standard 3/4 in. Weldon shank cutters, or an optional 3-jaw chuck is available for use with twist drill bits. The strong two-coil magnet provides 2,300 lbs. of deadlift force on 1 in. thick steel. The simple two-button control panel is located on the back, away from feed handle obstruction. The feed handle can be conveniently relocated to the opposite side without the use of tools.

FEATURES

•   Powerful 9.0 amp 1.1 max HP motor
•   Light weight, only 26.5 lbs. with comfortable carrying handle
•   Capacity to cut up to 1-1/2 in. diameter holes thru 2 in. steel with annular cutters, or 1/2 in. diameter holes, 4-1/4 in. deep with twist drill bits
•   Strong two-coil magnet
•   Two positions for feed handle -
•   relocate without tools
•   Simple two-button control panel - unobstructed by feed handle
•  

SPECIFICATIONS

 MILW4270-20

• Voltage 120 AC
• Amps
• 9.0
• Drill Capacity 1/2 in.
• No Load Speed 450 RPM
• Cord Type 8 ft. Fixed Construction Type Grounded 
• Electronic Feedback Yes
• Tap Capacity Drill Point Pressure 750 lbs. 
• Adjustable Base
• No Drill Travel 6.6 in.
• Chuck or Taper Weldon 
• Tool Weight 26.5 lbs.
• Shipping Weight 35.0 lbs.

INCLUDES 

• Lubricant Spray Bottle
• Nylon Safety Strap 
• Two Hex Wrenches
• Carrying Case for Electro Magnetic Drill Press,
• Tool and accessory storage